Tag Archives: IPC-A-610

What are acceptability requirements for a board…?

IPC Vice President David Bergman explains new requirements from IPC-A-610 for soldering two boards together.

Does my company need to start using the new revision of a standard?

IPC Vice President David Bergman answers this online technical question regarding what EMS companies should do about the new revision to IPC-A-610

Are through-hole parts connected through a common conductor acceptable?

IPC Vice President David Bergman answers this video tech question of the week on whether parts joined by design form an unacceptable solder bridge.

Which IPC standard should be used in this case of a lifted land?

Technical Question of the Week: Which IPC standard should be used in this case of a lifted land?

What do IPC standards say about acceptability of solder balls?

Technical Question of the Week: What do IPC standards say about acceptability of solder balls?

Which IPC standard is the right one to use for determining conformal coating thickness?

Technical Question of the Week: Which IPC standard is the right one to use for determining conformal coating thickness?

What do IPC standards say about measles?

Technical Question of the Week: What do IPC standards say about measles?

Are the requirements for hot tear in IPC-A-610 too restrictive?

Technical Question of the Week: Are the requirements for hot tear in IPC-A-610 too restrictive?

Follow

Get every new post delivered to your Inbox.